Free Standing Murphy Bed – A Murphy bed, also known as a bed-in-a-door, is an idea of space-saving furniture that has distinct advantages over conventional furniture. The bed can be folded up to make room for entertainment, work or hobbies. Make a Murphy bed for a fraction of the cost of a Murphy bed purchased. Murphy beds are designed to fold up in a frame that is against the wall. They are often found in apartments, bedrooms and other areas of small housing. Murphy beds can also be mounted inside wardrobe walls to save on space. Beds can be expensive when buying directly.
Building your own free standing murphy bed can save drastically in cost and allows you to have a bed ready for any unexpected guest. Assemble 2 by 4 inches of boards to make the frame for the mattress. The upper and lower plates will be inside the side panels. Insert two screws into each corner joint. It must have a rectangle of 2 by 4 boards. Place one of the pieces of plywood on the frame, flush with the top edge. Insert 2-inch screws through the plywood into the 2-by-4 boards every 6 inches around the structure. Place the second piece of plywood and the screw in place. Screw 1 by 6 inches together to the plywood, which covers the line where the two pieces of plywood meet.
This adds stability and hides the joint. Flip the entire piece over and install the flat supports (repair). Space them evenly across the width of the bed and screw them in place with 1/2 inch screws. Screw together two of the two 8-inch by 6-inch long boards to make a foot of the free standing murphy bed . Unit four of the 3-inch long screws in the block, turn it over and screw four more on the other side. Repeat the procedure to make one more (you must have four of those remaining pieces). Fit the remaining four-bed feet to the 2 x 12-inch board.